2
MOUNTING
HOLE
MOUNTING
HOLE
IMPORTANT:
THIS DEVICE MUST BE PERMANENTLY
MOUNTED WITH THE SCREWS SUPPLIED.
HOLDUP SWITCH SHOWN MOUNTED
IN TYPICAL UNDER COUNTER APPLICATION.
5869-004-V0
BREAKAWAY
TAMPER
SCREW
No. 6X3/4
MOUNTING
SCREW (2)
No. 6X2
MOUNTING
SCREW (2)
No. 6X2
+
COVER
SCREW (2)
No. 6x1/2
COVER
SCREW (2)
No. 6x1/2
+
Figure 2. Typical Holdup Switch Installation
SPECIFICATIONS
Physical
1-15/16"W x 5-15/16"H x 1-3/16"D
(50mm x 150mm x 30mm)
Battery
3-volt Lithium. ADEMCO 466, Duracell
DL123A, Panasonic CR123A, Sanyo CR123A,
Varta CR123A, or equivalent.
Frequency
345MHz
Reset Key:
Supplied, Part Number K4563 to order
separately
Agency:
UL 636 – Holdup alarm units and systems
C
US
LISTED
R
TO THE INSTALLER
Regular maintenance and inspection (at least annually) by the installer and frequent testing by the user are
vital to continuous satisfactory operation of any alarm system.
The installer should assume the responsibility of developing and offering a regular maintenance program to
the user, as well as acquainting the user with the proper operation and limitations of the alarm system and its
component parts. Recommendations must be included for a specific program of frequent testing (at least
weekly) to insure the system's operation at all times.
FCC ID: CFS8DL5869-1
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause
undesired operation.
CANADA: 573F-58691
