ADE PWI30, Руководство по эксплуатации, Страница: 6 / 16

5 PWI30-190920-Rev005-UM-en
- The charge status is indicated by on the display. Charge the battery as soon as a
low charge status is indicated by flashing charge status or LO lights up on the display
and the scale turns off automatically.
- When charging, make sure that the adapter is at least 5 cm away from metal objects.
- If the operating time with fully charged batteries is drastically reduced, the battery must
be replaced. In this case, please contact your local dealer or service partner.
- Make sure that the local mains voltage matches the operating voltage printed on the
adapter.
- If you will not be using the scale for an extended period of time, disconnect the power
supply from the mains and remove the battery to protect the scale.
- The energy transfer between the induction charger and the scale is contactless. The
radio symbols
indicate the position of the transmission and reception elements (top
side of the induction charger and in the area of the induction charging base of the
scale). Charging takes place only when both elements/symbols are opposite each
other!
- The charging function is available only if the distance between the transmission and
reception elements is sufficiently small. It is therefore necessary to ensure that the
induction charger is properly positioned in the induction charging base.
LED display for induction charging
Slide the induction charger

into the induction
charging base

and connect the charging adapter

to the local mains supply.
The printed voltage level must comply with the
local voltage.
The batteries in the scale will start to charge.
The induction charger LED indicates the charge status as follows:
Charger LED Battery symbol on the display Charge status
LED off Current battery status indicator Charger is not connected to mains.
LED steady green Evenly rolling battery symbol Charging is ongoing
LED steady green no battery symbol Charging is complete or mains
operation (without batteries)
LED steady red Current battery status indicator Charger connected to mains, but not to
scale.
LED flashes red and green Current battery status indicator Sensor fault.
If the scale is turned on, the charging process will be indicated by a rolling battery symbol
on the display. Once charging has been completed, the rolling will stop.