Compact USB Duplicator controller user manual
Page 14 of 17
6.5. Check Before Copy
This option allows to check device real capacity before copying. By default this option is
disabled
.
Use ▲or ▼ to select
6.6. Set Slow Out Threshold
This function allows to set up read/write speed threshold for target devices. When the target
device is causing the copy or compare process delay due to its lower read/write speed and
the rest of the devices in the same batch have to wait for it, the Slow Out Threshold strategy
will be applied as the following: the system will stop the copy or compare process for that
particular target device when its read/write speed is below the threshold for continuing
number of seconds based on the setting, and its red LED will flash to give warning. There are
3 settings to set up.
Read:
set up the lowest read speed
，
and options are OFF, 1MB/s~25MB/s. The default
setting is
OFF
.
Write:
set up the lowest write speed, and options are OFF, 1MB/s~25MB/s. The default
setting is
OFF
.
Duration:
set up the period when read or write speed is lower than the threshold for
continuing number of time, and options are 1~20second. The default is
5second
.
[Setup]
5. Check Before Copy
[
Check Before Copy
]
Disable
ENT
Use
▲▼to change option
ENT
ENT
[Set Slow Out Thresh>]
Read: OFF
6.Setup
[Setup]
6. Set Slow Out Thresh>
[Set Slow Out Thresh>]
Duration: 5sec
Setup Complete!
ENT
ENT
[Set Slow Out Thresh>]
Write: OFF
ENT
Use
▲▼to change option
Use
▲▼to change option
