www.addonics.com
Technical Support (M-F 8:30am - 6:00pm PST)
Phone: 408-453-6212
Email: www.addonics.com/support/query/
The Duplicator Panel
There are four buttons and an LCD on
the panel of HDD Duplicator.
1. LCD shows a function or a
message.
2. Use to scroll up function menus.
3. Use to scroll down function menus.
4. Use to execute a function.
5. Use to cancel a function.
ENT
ESC
2
1
4
3
5
Duplicator Panel
Duplicating a drive
When the duplicator powers on, it initializes and goes through the steps
below.
Copy HDD copies data directly from the source hard disk to the target hard
disk. Press ENT button to begin copy. The system will auto-detect the
hard disks and show the following info on the LCD.
The LCD will show the following info during the copying process: remaining
time, completed percentage. The copy speed, capacity and time will vary
depending on the source hard disk. Once the copying process is complete
the LCD will display the following results.
HD Duplicator
1-1 Ver:
Shows the firmware version
Initialize SDRAM
Initialize SDRAM’s Status...
Detect Drives
Copy-36 MB/s 0%
235.7GB 1 : 48
Copy HD
OK:
Detect Drive’s Status
1: Copy HD
Shows the first function