Chapter 4
Using the DVD±R/RW DigiCopier as a Stand Alone
DVD±R/RW Copier
#
Connect the power cable to the back of the DVD DigiCopier.
#
Plug in the Power Cord to the AC Power Source
(+90~+250VAC)
#
Set the switch (S1 on figure 1, page 6) at the back to Duplicator
position. Then turn the power on at the front to start the DVD
DigiCopier as a Stand Alone DVD Copier
#
LED Display will now lit at the front, will do a series of check, will
check Firmware version. Once the initiation is completed (about
10 -15 seconds), the Power light will stay lit.
#
You are now ready to use the
DVD±R/RW DigiCopier.
#
Insert a source DVD or CD on the top DVDROM Drive,
#
Insert a Blank DVD±R, DVD±RW, CD-R or CD-RW Disc at the
Bottom DVD±R/RW drive
#
Close the Tray and that’s it.
#
Once the copy is done, the bottom tray will open and you may
now use the created Disc.
Note:
The duplication time depends on the amount of data on the source
and the type of media in the destination drive. A full 680MB CD takes
approximately 6 – 7 minutes to copy onto a 16X certified CD-R. A full
Addonics Technologies –
DVD±R/RW
DigiCopier Users Guide v1.0
7