10
INST
ALLA
TION
12V
DC
12V
DC
Power in
A power adapter is supplied with a country-
specific power cord. The power adapter uses
a locking-type plug to help prevent accidental
disconnection; please follow the instructions
shown on the right when disconnecting a
power adapter.
Note: When first powered on and booting up, the
indicators and screen of the ALIF3000 unit will
not respond for roughly 40 seconds.
To connect the power adapter
1 Attach the output plug of the supplied
power adapter to the power input socket
on the left side of the rear panel. As you
insert the plug, pull back slightly on the
outer body to assist the locking mechanism
until the plug is fully inserted.
2
Insert the IEC connector of the supplied country-specific power cord to the socket of
the power adapter.
3 Connect the power cord to a nearby mains supply socket.
To disconnect the power adapter
1 Isolate the power adapter from the mains supply.
2 Grasp the outer body of the power adapter plug
where it connects with the node.
3 Gently pull the body of the outer plug away from
the node. As the body of the plug slides back, it will
release from the socket and you can fully withdraw
the whole plug.
IMPORTANT: Please read and adhere to the electrical safety information
given within the Safety information booklet provided with this product. In
particular, do not use an unearthed power socket or extension cable.
Note: The unit and the power adapter generate heat when in operation and will become
warm to the touch. Do not enclose them or place them in locations where air cannot circulate
to cool the equipment. Do not operate the equipment in ambient temperatures exceeding
40 degrees Centigrade. Do not place the products in contact with equipment whose surface
temperature exceeds 40 degrees Centigrade.
From the
power adapter
Gently pull back the plug outer
body to release the lock
ALIF3000 RX
POWER
IN