ADDAC System ADDAC104, Инструкция по сборке, Страница: 8 / 12

ADDAC SYSTEM page 8
STEP 8:
Next proceed to prepare the vactrols, bend all legs down (logo facing up) and cut them aprox. 12mm like
shown below.
ADDAC104 Assembly Guide
STEP 9:
Start by getting the vactrol in place than solder each leg flush to the pcb , do not insert the vactrol legs
all the way down as this may cause shorts on front side of the pcb. Solder them as flush as possible and
in the orientation shown below.
+