Adcraft VS-300, Инструкция по эксплуатации

Страница: 4 / 10

October 2016
Adding Oil to the Vacuum Machine
Starting Up the Vacuum Machine
1. Prepare the oil - Fill the empty oil bottle with the oil that comes with the machine.
2. Remove the back panel - Using a Phillips head screwdriver, remove the four screws from the
back panel and take the panel off the machine.
3. Remove the oil fill bolt - Locate the oil fill bolt on the vacuum pump and remove it using an
adjustable wrench or simular tool.
4. Fill the pump with oil - Insert the spout inot the open hole and begin pouring the oil into the
pump. Fill the pump until the oil level is at 1/2 to 3/4 in the site glass. This is approximately
3 - 3 1/2 ounces of oil.
5. Replace the oil fill bolt and back panel - Once the pump is filled with oil, screw the oil fill bolt
back in place and put the back of the panel on the machine.
1. Attach the power cord and plug the machine in.
2. Open the lid
3. Turn the power switch on - red power switch is located
on the left side of the unit. Once turned on an indicator
symbol with show on the control panel.
Back of housing
cabinet
Oil fill bolt
Oil site glass
NOTE: OIL MUST BE ADDED TO THE MACHINE PRIOR TO USE. MAKE SURE THE UNIT IS
TURNED OFF AND UNPLUGGED BEFORE ADDING OIL.