Servicing
ADCOM has a technical service department to
answer questions pertaining to the installation and
operation of your unit. In the event of difficulty, please
contact us for prompt advice. If your problem can not
be resolved through our combined efforts, we may
refer you to an authorized repair agency, or authorize
return of the unit to the factory. To aid us in directing
you to a convenient service station, please indicate
which major city is accessible to your home.
Trouble shooting
email and website info:
[email protected] www.adcom.com
[email protected] www.adcom.com
[email protected] www.adcom.com
[email protected] www.adcom.com
[email protected] www.adcom.com
Please include a return e-mail address for the reply.
Please address all mail inquires to:
ADCOM Service Corporation
10 Timber Lane
Marlboro, NJ 07746 USA
Please include a return address for the reply.
Phone or Fax inquiries to:
Phone (732) 683-2356
Fax (732) 683-9790
Mon - Fri 9AM - 5PM EST
Please direct inquiries to:
ADCOM Service Department
Please include a return fax number for the reply.
Symptom
-Unswitched LED does not
come on when the ACE-
315 AC power cord is
plugged into an outlet
-Power button pushed in,
but switched outlets are off
Possible Causes
-Outlet may be shut off
at the main breaker box
-Unit may be in standby
mode
-Remove any plug in
the 12v trigger jack
P
RE
SS TO RES
ET
CI
RC
UIT BREAKE
R
power 120v 60Hz
max 1800W
12v trigger
in
GND
WARNING: For indoor use in dry locations only.
To reduce the risk of shock, do not expose this
unit to rain or moisture.
10 Timber Lane
Marlboro, NJ 07746 USA
Made in the USA
WARNING: Equipment with high-current requirements, such as hobby arc-welders, hair
dryers and heaters must not be plugged into these AC receptacles. Never allow total power
consumption of all equipment connected to these outlets to exceed 1800 watts.
Surge Protector and AC Enhancer model ACE-315
voltage: 120V AC/60Hz, internal power consumption: 10w max
switched
unswitched (always on)
serial #
max 1800W
in
out
coax
in
out
phone
bank 1
bank 2
Typical Connections
to AC outlet
amplifier 2
CD
DV
D
amplifier 1
preamp
VCR
from wall
to device
from wall
to device
from preamp
preamp
Technical Specifications
Electrical
Input power..........................................120VAC, +/-10%, 5-/60Hz
Protection.......................................................15A Circuit Breaker
Internal Power Consumption.........................Less than 5 watts
Control Input..................................................+/-5V to 24V AC/DC
Total Output................................................................................15A
Environmental: Operating Temperature...............0 to +50 C
Storage Temperature...............-40 to +80 C
Filter
Noise: Normal Mode................-5dB at 5kHz; -38 dB at 300kHz
Common Mode........-3dB at 300kHz; -40 dB at 1 MHz
Surge Protection
Endurance................................................1,000 surges 6 kV; 3 kA
Clamping.............................................................................172 volts
Response Time..........................................................................0sec
(Passive protection / always on)
Maximum Applied Pulse (Combination Wave):
• Voltage: 6,000 volts
• Current: Unlimited due to current limiting
• Joules: Unlimited due to current limiting
Mechanical
Dimensions....17”(430mm) x 5-15/16” (150mm) x 3.5”(89mm)
Weight..........................................................................6 lbs (2.7 kg)
AC Cord............................................................................6 ft (1.8m)