Confidential
8/11/2008
7
Mounting the FlexWave™ nano
The location of each FlexWave™ nano is shown on the installation floor plan
produced at the network planning stage. The network wiring must be complete
before the FlexWave™ nano can be installed and commissioned. The FlexWave™
nano should be placed on a wall at or above head height or on a ceiling. Unless
explicitly stated otherwise, the following procedure is common for both 139/140 and
165 hardware variants.
Remove the FlexWave™ nano from the bracket by sliding the removal tool over the
central fin between the bracket and the body of the unit to disengage the locking
spring, slide bracket to separate it from the main body of the unit. The tool may be
inserted from the top or bottom of the FlexWave™ nano
Figure 12 - FlexWave™ nano Bracket Removal
Position the bracket on the wall and mark the position of the four screw holes. The
top of the bracket MUST be positioned uppermost. Ensure that the bracket is level
and sufficient clearance is maintained to allow the unit to be located on the bracket
(at least 80mm from the bracket to the top of wall and 120mm from the side of the
bracket to a side wall). See the diagram below, Figure 13 - Fixing the wall bracket.
80m m m in
120m m m in
Figure 13 - Fixing the wall bracket
© 2008 ADC Telecommunications, Inc.
Page 16