ADC ES50/50, Руководство по обслуживанию

Страница: 21 / 32

450353- 1 www.amdry.com 21
To Replace Front Panel
1. Discontinue electrical power to the dryer.
2. Follow procedure for removal of “control door and lint door/toe panel.”
3. Remove main door assembly.
4. Open control (service) door and follow procedure for removal of computer panel if replacing bottom panel.
5. Remove two TORX
®
T-20 screws above lint drawer to left and right side.
6. Remove the two TORX ® T-20 screws securing front panel to the dryer one top left and one top right of side
panel.
7. Loosen belt to allow for easier removal of panel.
8. Remove wires running up through front panel.
9. Pull top of panel out until roughly a 35 degree angle and then lift to remove.
10. Reverse this procedure for installing new front panel.
11. Tighten belt to original specifications.
12. Reestablish electrical power to the dryer.
To Replace Tumbler
1. Discontinue electrical power to the dryer.
2. Remove tumbler belt from motor.
3. Follow procedure for removal of front panel assembly.
4. Remove the four screws at the backside of the tumbler holding the dome shaped plate.
5. Remove tumbler assembly from front of dryer.
6. Reassemble components onto dryer by reversing steps 2 through 5.
7. Reestablish electrical power to the dryer.