®
AMERICAN DIAGNOSTIC CORPORATION
AMERICAN DIAGNOSTIC CORPORATION
55 Commerce Drive
Hauppauge, NY 11788
Customer Service: 1-800-ADC-2670
Voice: 1-631-273-9600
Fax: 1-631-273-9659
email: [email protected]
http://www.adctoday.com
NEW YORK • LONDON • TOKYO
©2015 ADC
®
IB p/n: 9352B-00 - rev 6
To Register Your Product,
visit us at
www.adctoday.com
and follow the links
• Mobile Aneroid
Assembly
Instructions
• Schematic
• Parts List for
Mobile Stand
• Wall Aneroid
Mounting
Instructions
Diagnostix
TM
752M, 750W Aneroids
®
Wall Mounting
Instructions for the
Diagnostix
TM
750W
Tools Needed
• Medium phillips head screwdriver
• Hammer
• Drill with 3/16” drill bi
t
Directions
1. Position manometer (with attached wall bracket) on wall
at desired location and rotate gauge to right side to
permit access to left side mounting holes on bracket.
Make pencil marks on wall through the mounting holes.
Holding bracket firmly in place, rotate gauge to left side
to permit access to right side mounting holes. Make
pencil marks on wall through the mounting holes.
Recommended height is near the eye level of the
intended users.
2. At each of the four pencil marks, drill a 3/16” hole
approximately 7/8” deep. Use a masonry type bit if
drilling through ceramic tile.
3. Gently tap the 4 screw anchors into the holes until they
are flush with the wall.
4. Position the manometer and bracket over the screw
holes and screw bracket into wall first on one side, then
the other using the procedure outlined in step one to
gain access to each of the four mounting holes. Take
care not to over tighten screws.
5. Attach 8 foot length of coiled tubing to air inlet at bottom
of manometer.
Insert “male” luer connector on free end of coiled tubing
to “female” luer connector on bladder tubing. Wrap cuff
around bulb and store in mounting bracket/storage
compartment behind gauge.
Note: If the mounting hardware supplied is not suitable for the
application, select hardware of adequate size and type to secure
the instrument firmly to the wall.
Important: The instrument is designed to permit wall mounting
without having to first remove the bracket from the instrument.
If the instrument is removed from the bracket for mounting or
service, we recommend applying removable loctite
®
to the
bracket hardware to prevent the instrument from working loose.
Locktite can be obtained from most hardware stores.
Main Unit
Wall Bracket
CAUTION:
Ensure that the unit is securely mounted
prior to use to avoid damage to the instrument
and/or potential injury.
®
