When you are done, perform steps 5 and 6 on this page to again lock the ID Lock.
5. On the remote control, press
STB
once; it will blink once. Then press and hold
SETUP
until the
STB
key
blinks twice.
6. Enter
9 8 2
. The
STB
key will blink twice, indicating ID Lock is again locked.
PROGRAMMING MACRO KEYS
The Potenza ST Universal Remote Control includes two macro keys (located directly below the
MUTE
and
LAST
keys). Macro keys allow you to set up key macros to activate certain keys in a specific order. For example, you can set up
a key macro to change the channels on your TV, raise or lower the volume, and start recording on your VCR, all with the
touch of one key. If you want to change the macros stored in a previously-programmed macro key, you’ll need to clear the
key first (see “Clearing a Macro Key” on page 13).
Programming a Macro Key
1. On the remote control, press and hold
SETUP
until it blinks twice.
2. Enter
9 9 5
. The
SETUP
key blinks twice.
3. Select a macro key (for example,
F1
) and press it once.
4. Press the key sequence you want to program into the macro. For example, to turn on your TV and raise its
volume, press the
TV
mode key once, followed by pressing the
VOL+
key once.
NOTE:
You can program up to 15 key presses into one macro.
5. Press and hold
SETUP
until it blinks twice.
6. To add another macro, repeat steps 1 through 5, substituting the new key sequence to be added in step 4.
NOTE:
Programming more than five macros on the same macro key overwrites previous settings.
Clearing a Macro Key
1. On the remote control, press and hold
SETUP
until it blinks twice.
2. Enter
9 9 5
. The
SETUP
key blinks twice.
3. Press the macro key you want to clear once.
4. Press and hold
SETUP
until the active mode key blinks twice.
This macro key is now clear and ready for reprogramming (see “Programming a Macro Key” on page 13). If desired,
repeat these to clear another Tune-In key.
USING THE MASTER POWER KEY
The Potenza ST Remote Control has a unique feature that allows you to sequentially turn up to five of your home
entertainment devices on or off with a single key press.
NOTE: MASTER POWER (POWER)
only works in the
STB
mode. If it is not programmed, only
the set-top box will turn on or off. In any other mode, pressing
MASTER POWER (POWER)
once will
turn the selected device on or off.
Programming the Master Power Key
1. On the remote control, press and hold
SETUP
until the last-selected device key blinks twice.
2. Enter
9 9 5
. The last-selected device key blinks twice.
3. Press
POWER
once.
4. For the first device you want in the power on sequence, press a device key (e.g.,
STB
) once. Then press
POWER
once. For the second device in the power sequence, press its key once (e.g,
TV
). Then press
POWER
.
5. Repeat step 4 up to four more times to add the second, third, fourth, and fifth device, as desired.
6. To save the settings and exit the program:
a. Press
STB
once.
13
