TV Spotlights
Page 6
Advice before Use
•
Read carefully these instructions.
•
As soon as the equipment is delivered, open packings and
inspect the equipment carefully.
If you notice any damage, contact immediately the transport
company and register your complaint in due form with
mention of the defects.
Be sure that this equipment left our factory in perfect
condition.
•
Check if the received equipment is consistent with the
delivery notice and if this delivery notice is consistent with
your order.
If it is not, contact immediately your supplier.
General Remarks
This luminaire is a lighting equipment designed for professional
use only in theatres and indoor television or film studios.
Designed and built in accordance with EN 60950 safety
regulations, it must imperatively be connected to earth by
means of its earth wire. It also complies with the CEI safety
regulations (598-1/598-2-17 publications).
To prevent any electrical shock, there is no need to open this
equipment when functioning.
Nevertheless:
•
Any part or lenses have to be replaced if they are visibly
damaged and their efficiency might be reduced, for example
in case of deep cracks or scratches.
•
Lamp must be changed if damaged or distorted by heat.
If internal access is needed for control, service or repair purposes,
always refer to qualified personnel.
In all events, always unplug the power supply cable before
opening.
LETHAL
VOLTAGE
PRESENT
INSIDE
It is the user's responsibility to use the luminaire for its intended
purpose and to check the equipment that might be connected
to it.
The luminaire can under no circumstances be modified.
ADB will not assume any responsibility in case of damage
resulting from modications made to the luminaire.
This luminaire is a piece of professional equipment designed for
easy and simple use. Nevertheless, always refer to qualified
personnel for any installation or repair work.
Important Remarks:
Power supply cables and other connections are essential for
your equipment and contribute greatly to a safe and trouble free
operation.
•
Always hold the plug when disconnecting a cable, never pull
the cable.
•
Never use cables or connectors in bad condition, check
them before installation and periodically thereafter.
•
Never tie power supply and data cables together.
Fitting the Lamp
ALWAYS disconnect the supply cable from the mains.
Set the switch into the "OFF" position.
Open the front door by pulling on the lever of the door catch
(see Fig. 1).
Place the lamp into the socket.
The type G38 socket is equipped with a lever permitting the
contact jaws to be separated in order to facilitate this operation.
Please refer to the index plate to establish the type of lamp to
be used. Please consult the manufacturer's instructions supplied
with the lamp so as to use the lamp in the proper manner.
The lamp MUST be replaced if it has been damaged or
deformed by heat.
Electrical Connection
Your spotlight has been designed to operate at a maximum
voltage of 220-240V. It must be connected to the mains using
a 3-core cable, the cross-section of which is suitable for the
power of the lamp, in accordance with the local regulations. We
recommend a cross-section of 2.5 mm
2
for 1 kW and 2 kW
spotlights and a cross-section of 4 mm
2
for 5 kW spotlights. The
insulation of the cable must withstand the maximum temperature
when operating under load, as stated on the index plate.
Refer to the attached figure 3. Unscrew the 4 screws from the
terminal box in order to gain access to the terminals. Insert the
cable into the cable clamp; connect the green/yellow conductor
to the earth terminal; connect the other two conductors to the
terminals. Immobilize the cable by tightening the screws of the
cable clamp; and screw on the cover of the terminal box.
