Remote Control Programming Instructions
Main Set Up
-- You can set-up the remote to control other devices (television, dvd, vcr, etc)
1. Make sure the device you wish to operate is switched
on
(not in standby).
2. Find the code for the device in the Code List. If your brand is not listed, skip to Search Method.
3. Press the
device key
(e.g. TV) on the remote for the device you want to set up.
4. Press and hold down
SHIFT
until the red light blinks twice (it will blink once, then twice).
5. Enter your
four-digit code
using the number keys. The red light will blink twice.
6. Aim the FOCUS remote at your device (e.g. television) and press
POWER
. If your device
switched off, your remote is ready to operate your device.
Most TV’s do not switch back on pressing the POWER key. Try pressing a “number” key or the “TV-text off”
key to switch your TV back on. If your device does not respond, follow steps 1 - 6 again for each code listed
for your brand. If none of the codes listed work, then try the Search Method below. When you find a code
that works, write it down on this page and in the battery compartment of the remote for future reference. Only
one device can be assigned to a device key on the remote.
Search Method
-- Use if your devide does not respond to the remote after you have tried all the codes listed
for your brand OR if your brand is not listed at all.
1. Switch your television (or other device)
on
(not in standby mode).
2. Press the
TV
(or other device key) on the remote.
3. Press and hold the
SHIFT
key until the right light blinks twice (it will blink once, then twice).
4. Press
9 9 1
. The red light will blink twice.
5. Next, press
a function
.
6. Aim the remote at the device. Now press
PROG+
over and over, in order to scan through
the codes available in the memory.
You may have to press this key up to 150 times, so please be
patient.
If you skip past a code, you can go to the previous code(s) by pressing the PROG- key.
Remember to keep the remote pointed at the device you are trying to setup.
7. As soon as you have found an appropriate code, press SHIFT key to store the code. Now write
that code down on this page and transfer to battery compartment of remote when finished.
Code Blink Out
-- Once you have setup your remote, you can blink back your set-up code for future refer-
ence. Follow the steps and write the code(s) down on the spaces below.
1. Press the
TV
key once
2. Press and hold down
SHIFT
until the red light blinks twice (it will blink once, then twice).
3. Press
9 9 0
. The red light will blink twice.
4. For the first digit of the four-digit code, press
1
and count all the red blinks. If no blinks, the digit is “0”.
5. For the second digit of the four-digit code, press
2
and count all the red blinks. If no blinks, the digit is “0”.
6. For the third digit of the four-digit code, press
3
and count all the red blinks. If no blinks, the digit is “0”.
7. For the fourth digit of the four-digit code, press
4
and count all the red blinks. If no blinks, the digit is “0”.
8. Now you have the set-up code. To get code(s) for other devices you have setup, repeat these
steps but press a different device key.
Device Codes:
Device 1 _______________ Code 1 _________ Device 2 _______________ Code 2 _________
Device 3 _______________ Code 3 _________ Device 4 _______________ Code 4 _________
17
