ADB Safegate EREL, Руководство пользователя

Страница: 43 / 50

5.0 Troubleshooting
5.1 Operation Safety
CAUTION
Improper Operation
Do Not Operate this equipment other than as specified by the manufacturer
• Only qualified personnel, physically capable of operating the equipment and with no impairments in
their judgment or reaction times, should operate this equipment.
• Read all system component manuals before operating this equipment. A thorough understanding of
system components and their operation will help you operate the system safely and efficiently.
• Before starting this equipment, check all safety interlocks, fire-detection systems, and protective
devices such as panels and covers. Make sure all devices are fully functional. Do not operate the
system if these devices are not working properly. Do not deactivate or bypass automatic safety
interlocks or locked-out electrical disconnects or pneumatic valves.
• Protect equipment with safety devices as specified by applicable safety regulations.
• If safety devices must be removed for installation, install them immediately after the work is
completed and check them for proper functioning.
• Route electrical wiring along a protected path. Make sure they will not be damaged by moving
equipment.
• Never operate equipment with a known malfunction.
• Do not attempt to operate or service electrical equipment if standing water is present.
• Use this equipment only in the environments for which it is rated. Do not operate this equipment in
humid, flammable, or explosive environments unless it has been rated for safe operation in these
environments.
• Never touch exposed electrical connections on equipment while the power is ON.
Failure to follow these instructions can result in equipment damage
5.2 Troubleshooting guide
Table 1: Troubleshooting guide
Problem Possible cause Possible solution
Only one side of the
fixture has light
output
The LED MCPCB has a malfunction Replace the optical kit. See § Part replacement - optical kit .
Both sides of the
fixture have no light
or light flickers
The connection to the series circuit has a
malfunction.
Examine the electrical connection, the cable and the receptacles.
The input power has a malfunction. - Disconnect the plug from the secondary connection.
- Test the series circuit with a spare fixture.
- If the light is ok, replace the complete optical head. See § Part
replacement - complete optical head .
- If the light is not ok, adjust the input power.
- Troubleshoot the series circuit.
Connection of the body assembly to the LED
module has a malfunction.
- Remove the optical cover.
See § Part replacement - optical cover .
- Check the electrical connection between the LED MCPCB and the
body.
The body assembly has a malfunction Replace the body. See § Part replacement - arctic kit (arctic kit
option) .
AM.03.120e, Rev. 3.4, 2019/03/29 37
Copyright
©
ADB Safegate, All Rights Reserved