12
x1
First time use and after power cuts of over
60 minutes
USER GUIDE
When putting Adax Neo into operation or after a
lengthy power cut, the display will flash, showing
that no temp. reduction programme is active. Press
“F” to reset and the thermostat will revert to the
default settings: 22°C for normal temp. and 15°C
for reduced temp. The duration of temp. reduc-
tion is 7 hours at night and 5 hours during the day.
Temp. reduction is not activated.
Select the normal temperature
setting
Choose the desired normal
temperature by pressing
or .
Set the correct day of the week
Set the correct week-day by holding
down on “F” until “d” (d = day) is
shown in the display.
Press or until the appropriate
figure is displayed. Monday = 1,
tuesday = 2 etc. Store the setting by
pressing “F”, or allow it to be stored
automatically after appr. 30
seconds.
NB! The correct weekday must
be set at a time
later than
the
start of daytime temp. reduction.
What do flashing lights and steady
lights A and B indicate?
Slow flashing shows that a temp.
reduction period is ongoing. At the
same time the display will show the
temp. setting.
A steady light shows that Neo is pro-
grammed for temp. reduction, but that
it is not currently in an active period.
Cancel a period of temp. reduction
Hold down on “F” and press once
on “7” or “5” to override the
current active period, or the next
period of temp. reduction. The
lamp is lit steadily for the period
in question. Temp. reduction will
resume as usual from the
following period.
Delete a period of temp. reduction
Hold down on “7” or “5”
until the green lamp is
extinguished.
NEO
B
A
1
2
5
6
9
10
