Adastra 952.916, Руководство по эксплуатации

Страница: 4 / 28

Tuner section
(Fig. 3)
1. TUNER FREQUENCY DISPLAY
By means of this display, it is possible to
display the band and frequency of the tuner
and stored channel.
2. BAND SELECTION BUTTON
This button is used to select the FM1, FM2
or FM3 band.
3. STORE/PRESET STATION RECALL BUTTONS
(MEMO 1 - 6)
The purpose of these buttons is to recall the
six frequencies stored in the three different
bands. Altogether, a total of eighteen
transmission frequencies can be stored. The
same button is used to store the desired
transmission frequency. The procedure as
follows:
1. Select the band by means of BAND button
(2);
2. Select the frequency to be stored by means
of TUNE UP/TUNE DOWN button (4);
3. Press the store button (3) in which the
desired frequency is to be stored for at least
2-3 seconds
4. The present status of the tuner will be
memorised in the selected address.
When the button is pressed for over 3
seconds, a search is made for the next
strongest frequency.
4. UP/DOWN BUTTON
When the button is momentarily pressed
once, the FM frequency will adjust with a
single UP/DOWN count.
When the button is pressed for over 3
seconds, a search is made for the next
strongest frequency.
by the green “REPEAT” indicator in the
“FUNCTION” area (9).
By pressing the button twice, the complete CD
will be repeated. This function is indicated by
the simultaneous lighting up of the “REPEAT”
and “REPEAT ALL” indicator lights in the
“FUNCTION” area.
To disengage this function, press the button
until both indicator lights go off.
7. “PROGRAM” BUTTON
This button is used to programme a sequence
of tracks contained on a CD.
To perform the sequence to be listened to,
the CD must be stopped.
The total number of tracks in the CD appears
on the “PROGRAM” area display. By pressing
the button, the display will start to flash and,
by means of the “TRACK UP/DOWN” controls,
the desired track will be selected.
If the “PROGRAM” key is pressed again, the
desired track will be stored in the sequence
to be repeated. Perform this operation for the
desired tracks.
Once the choice has been made, press the
“PLAY/PAUSE” key to begin listening.
This function is indicated by flashing of the
“PROGRAM” indicator light in the "FUNCTION"
area. This indication will remain engaged
throughout programming.
8. DISPLAY MODE
This display unit shows the state of the source
on the AUX channel (CD, TUNER, AUX).
9. STATUS LED INDICATORS
These LEDs indicate the status of the CD. Their
meanings have been explained previously
according to function.
10. CD TRACK DISPLAY UNIT
This display unit indicates the number of the
track being listened to.
4
CH-4 AUX CH-3 CH-2
INPUT VOLUME
FM DIGITAL TUNER
952.916 CD-TUNER-AMPLIFIER
CD AUDIO PLAYER
TONE CONTROL
CH-1
0 10 0 10 0 10 0 10 0 10 -10 +10 -10 +10
BASS TREBLE MASTER POWER
0 10
+3
0dB
-3
-6
-9
ON
RANDOM
REPEAT
PLAY
ALL
0 0
PROGRAM REPEAT DOWN UP
AUX CD TUNER
TUNE
BAND
1 2 3
4 5 6
OPEN/CLOSE PLAY/PAUSE STOP
(1) (2) (4) (3)