©
2020 ATG. Signal Hill, CA 90755
(562) 424-1100
1220-rev00
Step 5: Setting the pan angle:
Rotate the speaker horizontally right or left until the speaker
is aimed in the desired direction. Permanently tighten the
hex bolt at the mounting plate (Figure 5).
Step 6: Setting the tilt angle
While supporting the speaker’s weight, lift the speaker up to
the desired tilt angle and hold it in position. Tighten the 3/4”
hex bolts at the sides of the speaker adapter plate, one is a
right hand thread and one is a left hand thread. Rotate the
left hand thread bolt on the grooved side of the pivot rod
counterclockwise to tighten. Rotate the other opposite bolt
clockwise to tighten. Be sure that the bolts have been
tightened permanently before releasing the weight of the
speaker (Figure 6).
If the tilt angle needs to be adjusted, DO
NOT PULL ON SPEAKER, rather loosen
the bolts then repeat step 6.
Step 7: Recommendation: Install Safety Cable
Attach a safety cable (sold separately) to the mounting
surface (Must be able to support at least five times the
weight of the speaker), then attach the other end of the
safety cable to the speaker. If no attachment is provided on
speaker, consult speaker manufacturer for advice on best
attachment point and method
Figure 5
Figure 6
