6
AVA-2902E/I Installation Guide
Part Number: 511444-00, Rev. A
Print Spec Number: 496495-00
Current Date: 3/26/97
ECN Date: 4/2/97
■
Here are some additional CMOS setup issues:
– If there is an Interrupt Type or Interrupt Line
option in the Setup program, select Int-A or
Interrupt Type = A
. Depending on your sys-
tem design, you may also need to change a
motherboard jumper setting.
– If there is a Triggering Interrupt option, select
Level
.
– If there is an option to enable or disable bus
mastering for the PCI slots, select Enabled.
– If there is an option to enable or disable indi-
vidual PCI slots, be sure the slot in which you
install the host adapter is Enabled.
– If your PC has ISA or EISA boards in addition
to the AVA-2902E/I adapter, you may need to
mark the IRQs used by the ISA/EISA boards
as Used so the system BIOS will not try to
assign these IRQs to PCI boards.
– In some PC systems the BIOS reserves a set of
available IRQs for PCI boards, and you have
to assign these IRQs manually.
FCC Compliance Statement
WARNING: Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user’s authority to
operate the equipment.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in
residential installations. This equipment generates, uses, and can radiate
radio frequency energy, and if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause interference to radio or
television equipment reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and receiver
•
Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected
•
Consult the dealer or an experienced radio/TV technician for a help
Use a shielded and properly grounded I/O cable and power cable to ensure
compliance of this unit to the specified limits of the rules.
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interfer-
ence and (2) this device must accept any interference received, including
interference that may cause undesired operation.
