Adaptec ARO-1130SA, Инструкция по установке и эксплуатации оборудования, Страница: 41 / 86

6-5
Installing Software on a Novell NetWare Server
3
Load the NetWare install program from the NetWare colon
prompt ( :load install ). Follow the instructions in the NetWare
documentation to complete the installation (e.g., creating disk
partitions, system volumes, etc.) of your server.
Installing the Driver When NetWare is Already Installed
To update or install the cda1000.dsk driver if NetWare is already
installed, follow the instructions in this section. The procedures are
similar for all versions of NetWare. Procedures that are specific to a
NetWare version are noted when necessary.
1
Copy the cda1000.dsk and aspitran.dsk files from the appro-
priate Adaptec Array1000SA Family Manager Set driver dis-
kette (Disk A or Disk B) into the server’s startup directory (e.g.,
c:\nwserver, c:\server.312 ) on your hard disk drive. (See Run-
ning the Array1000xA BIOS & Driver Selection Utility on page
3-2 to determine the appropriate driver diskette.)
Note:
For NetWare 3.12, the cda1000.dsk and
aspitran.dsk files are located in the \netware\v3_1x
subdirectory on the diskette; for NetWare 4.11, the files
are in
\netware\v4_xx .
2
If necessary, modify the load command line in the startup.ncf
so that the proper path to the driver is specified. The correct
syntax to load the
cda1000.dsk driver is
load [ pathname ]cda1000
Note:
If you unload cda1000.dsk driver, you must also
unload cioams.nlm . When you load cda1000.dsk driver
again, you must also load cioams.nlm . If cioams.nlm is not
unloaded when you unload cda1000.dsk , your system may
work erratically.