8
board. SCSISelect also contains SCSI disk utilities
that let you low-level format or verify the disk media
of your SCSI hard disk drives.
SCSI
Select Default Settings
The AHA-2940Ultra/2940Ultra Wide has the default
settings shown in the table on the following page.
The default settings are appropriate for most PCI
systems. If you do not need to change any of the
default settings, there is no need to run SCSISelect.
Your host adapter is ready for operation and you can
proceed to Installing Device Drivers on page 10.
For situations where you might want or need to
change the settings, see the descriptions of each set-
ting in the user’s guide. If you need to change any of
the default settings, or if you would like to format or
verify a disk, see Starting the SCSISelect Utility on
page 9 to start the utility.
SCSI Bus Interface Definitions
Default
Host Adapter SCSI ID
7
SCSI Parity Checking
Enabled
Host Adapter SCSI Termination
Automatic
Boot Device Options
Default
Boot SCSI ID
0
Boot LUN Number
1
0
SCSI Device Configuration
Default
Maximum Sync Transfer Rate
20.0 MBytes/sec
2
40.0 MBytes/sec
3
Enable Disconnection
Yes (Enabled)
Initiate Wide Negotiation
3
Yes (Enabled)
Send Start Unit Command
4
Yes (Enabled)
Enable Write Back Cache
N/C (No change)
BIOS Multiple LUN Support
4
No (Disabled)
Include in BIOS Scan
Yes (Enabled)
Advanced Configuration Options
Default
Plug and Play SCAM Support
Disabled
Reset SCSI Bus at IC Initialization
Enabled
Extended BIOS Translation for DOS Drives >
1 GByte
Enabled
Verbose/Silent Mode
Verbose
Host Adapter BIOS (Configuration Utility
reserves BIOS space)
Enabled
