4
2
Turn the drive chassis so that you can access the connectors on
the rear panel.
3
Using the Figure as a guideline, connect the cables. Use gentle
but firm pressure to fit the connectors together.
Caution:
The connectors are keyed to fit together one way
only. Do not try to force a cable onto a connector. If the
cable does not slide on easily, try reversing it.
a
Connect the LED cable to the LED connector, marked on the
backplane as JP26.
b
Connect a SATA cable to channel connector #1, rotating the
end of the cable until it fits properly onto the connector. Both
ends of the SATA cable are identical, but are keyed to fit the
connectors one way only.
Continue by connecting SATA cables to channel connectors
#2 – #4.
c
Connect two power supply cables to power supply connectors.
The connectors are shown in
detail in the next Figure.
!
Channel Connectors #1 – #4
(see the Table on page 3)
Power
Connectors
LED Connector
2410SA Enclosure Kit HIG.fm Page 4 Thursday, October 23, 2003 1:20 PM