Adamson POINT 115 SUB, Руководство пользователя

Страница: 39 / 40

Point Series User Manual Page 39 of 40
adamson systems .com
Processing, Amplification & Cabling
Processing
All processing is taken care of by the Point Control Digital Signal Processor.
Point Series Cabinets available in both Passive or Active versions.
Amplification
Adamson recommends the use of Lab.gruppen amplifiers for the entire Point Series range.
There are many different power handling options in the C:Series Installation range in both 4
and 8 channel models. and the FP touring series is also recommended for its ability to run
comfortably at a 2Ω load.
NOTE: Not all C:Series amplifiers will be able to handle a 2Ω load though some of the later
models are capable of this. It is up to the system designer to ensure the right amplifier is
used for the job.
Cabling
All speaker connections in Point Series range utilize standard Speakon™ NL4 connectors. The
minimum recommended cable gauge is 13 AWG or 2.5mm2 though for longer runs or when
running amplifiers at low impedences- a thicker wire gauge is recommended. All Point Series
cabinets feature a recessed rear-panel.
Barrier Strip
Available by request.
3.11
Parts and Terminology
1
1
2
2
3
3
4
4
A A
B B
C C
D D
ADAMSON SYSTEMS ENGINEERING
1401 SCUGOG LINE 6
PORT PERRY, ONTARIO, L9L 1B2
TEL:(905)862-0520 FAX:(905)862-0609
DATE : DRN:
SCALE: APPV'D:
DISK:
Z:\New Plan\PROTOTYPE\PRODUCTS\ENCLOSURES\New family\install 15_12\p15 back view.dwg
PROJECT:
DRAWING:
Dwg #:
Rev:
REV DATE CHANGE
p15 back view
PART NO.
8/13/2009
mark
SHEET 1 OF 1