If it becomes necessary to set the unit to the factory default settings Go To:
Settings >> Clear Setup >> Yes
Default Settings
Basic Troubleshooting
9
Unit does not turn on or unit receives no power.
a. Check power adapter light and power outlet to make sure power connections are secured.
b. Check power switch on the back of the unit is set to the correct position (
I
).
The Optical drive does not open and/or drive LED does not light up.
b. If a disc is stuck inside a drive, insert a paper clip or safety pin into the pinhole
underneath the drive door and push gently. Make sure the power is OFF during this step.
Press the EJECT button of the drive a few times to test the disc tray.
The blank DVD/CD/BD is not recognized in the Optical drive.
a. Test the blank disc in another optical drive. A faulty writer will not recognize blank discs.
b. Change the blank disc to another disc. A defective blank disc will not be recognized by
the writer drive.
a. Do not open the tower casing as this will void the warranty, unless instructed by an
authorized technician.
High Failure Rate
a. Change media type. Certain types of media may not be compatible with the drives. Poor
quality media can also cause a high failure rate.
b. Lower the burn speed using step
5.1
Machine becomes Hung Up
a. Holding down the ESC key to abort the copy process may cause the machine to become
hung up. If this happens turn OFF and then ON the DP-150 Series.
b. Change the Master Source. It may have errors on it, or be of too poor quality causing the
machine to become hung up.
Buttons do not work
a. Wait for the unit to finish its process.
For troubleshooting assistance contact
Adams Evidence Grade Technology, Inc.
Technical Support
Toll Free...877-643-4900
[email protected]
3.9.2 Setup Password
Allows user to set a password to protect from unauthorized changes to the Setup.
Press
to select character
Press
ENT
to confirm
Press
ENT
to move to the next position
Press
to select option
Press
ENT
to confirm
[Setup]
9 .
Advanced Setup
[Advanced Setup]
3.
Setup Password
3. Setup
[Setup Password]
Enable
[Setup Password]
==> _
[Setup Password]
==> _ _ _ _ _ _ OK?
3.9 Advanced Setup
3.9.1 Boot Password
Press
to select
character
Press
ENT
to confirm
Press
ENT
to move to the next position
Press
to select option
Press
ENT
to confirm
[Setup]
9 .
Advanced Setup
[Advanced Setup]
2.
Boot Password
3. Setup
[Boot Password]
Enable
[Boot Password]
==> _
[Boot Password]
==> _ _ _ _ _ _ OK?
ENT
ENT
ENT
ENT
ENT
ENT
ENT
ENT
Allows user to set up password for the copier to prevent unauthorized use.
Password can be up to 6 characters.
10
rev 11/19/2019
NOTE: IF PASSWORD IS LOST. PLEASE CALL TECHNICAL SUPPORT FOR A
ONE TIME MASTER PASSWORD
NOTE: IF PASSWORD IS LOST. PLEASE CALL TECHNICAL SUPPORT FOR A
ONE TIME MASTER PASSWORD
