background image

6

QUICK START GUIDE [ENGLISH]

Before using your new speakers, you should let them settle at the 
ambient temperature of your listening environment by leaving them in 
position for an hour or so after unpacking them. We recommend that 
the S Series speakers are driven on a solid, stable surface for best results. 
Please also be aware that before optimum performance can be  
attained, it always takes some hours of continuous usage to 'break in' 
factory-fresh reference monitors.

With the speakers connected to your audio source but turned off, and 
with the audio input to the monitors turned all the way down, the  
amplifiers should be connected to AC mains power via the supplied 
standard IEC cable. The switched-mode power amplifiers in the S Series 
loudspeakers can handle mains electricity from anywhere in the world, 
with a voltage and frequency range of 100 – 240 volts AC, 50/60 Hz, so 
you can plug the monitors in without having to worry about mains 
transformers or overheating. Then simply turn on the loudspeakers, 
start your playback audio, and gradually increase the output level of 
your audio source. You should now start to hear sound through your  
S Series speakers.

5. LOUDSPEAKER PLACEMENT

Assuming your room has been acoustically treated to a reasonable 
degree to remove the worst effects of unwanted reflections and room 
modes, much of loudspeaker placement is common sense, but there 
are a few basic points that should be followed:

→ Ensure that all your speakers are level with one another in the vertical 

plane [except subwoofers, for which placement is much less critical], 
and that the tweeters are roughly level with your ears. If a speaker 
needs to be placed higher or lower due to spatial constraints, it should 
be angled accordingly, but tilts of 15 degrees or more should be 
avoided [see diagram]. Angles that result in reflections from your 
mixing console or other significant studio furniture should also  
be avoided.

→ Make sure that nothing partially or totally obscures your monitors. 

You should have a clear line of sight to them; this will also guarantee 
that nothing comes between them and your ears.

4. GETTING STARTED

Содержание S2V









Отзывы: