Chapter 4 Deployment of the CPU 821xNET
CPU ADAM 821x
4-12
ADAM 8000 Manual CPU 821x – Rev 1.1
Configuration of the CPU 821xNET
The configuration procedure for the CP section is identical to that of the CP
143 H1/TCP/IP ADAM module.
The configuration procedure for H1 and TCP/IP consists of two parts:
•
CP configuration
by means of WinNCS of Advantech (Ethernet
connection).
•
PLC programming
by means of an application program (PLC connect).
The CP section of the CPU 821xNET may only be configured with WinNCS
from Advantech and consists of the following 3 parts:
•
The initial CP configuration,
•
configuration of connection modules,
•
transfer configuration data into the CP.
This is where the address and other identification parameters of a station
are defined.
Under "Ethernet" you insert a new station into the network window and
enter the configuration data for your station into the parameter window.
The basic CP configuration determines the behavior of your station on the
network.
Outline
CP-configuration
with WinNCS
Initial CP
configuration
