© Adam Equipment Company 2006
4
•
If the scale is still displaying a small weight when there is no
load on the platform, it needs to be zeroed. Press the
[Tare/Zero]
key to zero the display. The arrow above
Zero
will be on. If the zero display is not achieved then the scale
may need to be re-calibrated.
•
If the weighing value is to be tared to obtain the net value,
press
[Tare/Zero]
again. The arrow above
Tare
will be on.
•
The person to be weighed can step on to the platform now.
The weight will be displayed in Kg or lb depending on the
units chosen by the user.
•
Units:
Press the
[kg/lb]
key for changing the weighing unit to
kg or lb. An arrow will indicate towards the chosen unit.
•
Backlight:
The scale has an automatic back-light which is
switched on whenever time the scale is in use.
•
Overload display
: When “
OL
” appears on the display, it
shows that the load on the platform is over the maximum
capacity. It is necessary to reduce the load otherwise the
sensor or the platform may be damaged.
•
Hold Function:
To lock the weighing result, press the
[Hold]
key. The arrow indicator will point towards
Hold
and it will
show a steady reading even if the person on the platform is
moving or goes away from the scale and will not allow the
next weighing. To release the function, press
[Hold]
again.
•
Do not press the
[On/Off]
key if you do not want to weigh as
pressing the
[On/Off]
key will switch the scale to
ON
.
6.0
MEASURING HEIGHT
•
While measuring the height, it is necessary to pull up the
measuring board at a right angle with the inside tube.
•
When the tube is pulled out straight, it is sufficient to
measure the height from 80 to 126 cm. The number can be
obtained upon the conjoint place where the upper part of
middle tube screw meets with the inside tube scale.
