Adam Equipment Eclipse EBL Series, Руководство по эксплуатации

Страница: 28 / 116

EN
© Adam Equipment Company 2015
26
3016612482 Rev1-Aug15
10.4.4 Animal (Dynamic) Weighing
The balance can be set to weigh animals or unstable/moving items. This is commonly
referred to as ‘Animal’ or ‘Dynamic’ weighing mode. The balance will collect the weight
over a period of time to arrive at an average value and display the value until the operator
resets the balance. The actual weighing process can begin either automatically when the
weight is placed on the pan, or when initiated by the operator. The weighing unit can be
selected as normal using the [Unit] and [Select] keys, before starting the dynamic
weighing process.
Steps:
Press [Mode] and then the [Up] or [Down] key to cycle through available modes. When
the “
Animal
Animal Animal
Animal
” symbol is displayed, press [Select] to enter dynamic weighing mode.
“
Animal Animal Animal Animal
r rr rUN UN UN UN ” will now be displayed on the screen.
Press [Up] or [Down] to select “
RUN RUN RUN RUN ” for starting the dynamic weighing, or “ SEtvP SEtvP SEtvP SEtvP ” to set
up the balance for dynamic weighing (see section 10.4.4.3 on Dynamic Weighing Setup
Parameters).
Once Dynamic Weighing has started running, only the [Print] and [Mode] keys are lit.
[Print] pauses the sequence. The balance will display “ PAvSEd
PAvSEd PAvSEd
PAvSEd ” and show the
current calculated average weight. To resume, press [Print] again, or if you do not
wish to continue then pressing [Mode] will display “
StOPPED
StOPPED StOPPED
StOPPED ” and then show the
final average value.
[Mode] stops the operation. The balance will display “ StOPPE StOPPE StOPPE StOPPED DD D ” and then show the
final average value.
Once Dynamic Weighing run has completed or been stopped, the final value will remain on
displayed on screen until the user presses either [Select] or [Mode] to go back to “
rUN
rUN rUN
rUN ” to
weigh another item, or [ 0/T  ] to return to normal weighing. The [Print] key is also lit,
indicating that print output to a connected device is available. Print output will be the
measured weight as shown on screen.
10.4.4.1 MANUAL MODE
When the balance is in the “ MmANvAL MmANvAL MmANvAL MmANvAL ” mode:–
If [Select] is pressed when “
rvN rvN rvN rvN ” is selected, balance will display “ StArt StArt StArt StArt ”.
Place the item on the pan and press [Select] again.
After the pre-configured delay and test time have elapsed (see section 10.4.4.3 on
Dynamic Weighing Setup Parameters), the “
Hold
” symbol and the result will be displayed.
Remove the item from the pan. Press [Mode] to go back to “
rUN rUN rUN rUN ” to weigh another item, or
[ 0/T  ] to return to normal weighing.
10.4.4.2 AUTO MODE
When the balance is in the “ AvTO
AvTO AvTO
AvTO ” mode:–
If [Select] is pressed when “
rVN
rVN rVN
rVN ” is selected, the balance will display “ LOAd P
LOAd P LOAd P
LOAd P ”.