Page
21
Doc : AM210-001E Release: 1.4 updated : 2015
Sample ID-
identification of the jet fuel sample that was used for the oxidation test
Maximum length for Sample ID field is 15 characters.
In order to make an entry, touch the highlighted sensitive area. The virtual keypad will appear allowing
you to type in the required information. Proceed in the same way to pop up the virtual keypad for the
other field entries.
Sample type –
identification of the jet fuel type
Touch the arrow and select a name from drop-down list.
Refer to the section “Set pre-programmed lists” below in this manual about how to fill the list.
Operator –
identification of the person performing the DR10 test
Touch the arrow and select a name from drop-down list.
Refer to the section “Set pre-programmed lists” below in this manual about how to fill the list.
Temperature –
the test temperature of jet fuel oxidation in thermal oxidation stability rig
Touch the arrow and select a name from drop-down list.
Refer to the section “Set pre-programmed lists” below in this manual about how to fill the list.
Test Rig ID -
identification of the thermal oxidation stability rig that was used for the thermal oxidation of
the sample according to ASTM D3421 procedure. Touch the arrow and select a name from drop-down list.
Refer to the section “Set pre-programmed lists” below in this manual about how to fill the list.
