In the event you wish to manually change the clock settings, please use the
instructions on the following page.
3)
Choose Your Time Zone
– You must set your time zone so the clock will display
accurate time once the atomic signal is received:
a. Select your time zone by repeatedly pressing the
(
)
ARROW until you
see your time zone displayed on the LCD screen.
1)
Battery Installation
– remove the battery compartment cover on the back of the
unit and install 2 FRESH “AA” batteries as shown here.
2)
Initial Setup
– once the batteries are installed, the clock will power up.
The display will appear as follows:
The clock will begin searching for the Atomic signal
If the signal is AVAILABLE
– the clock will receive the local time in 3-5 minutes.
The full strength signal indicator bars will appear on the display.
If the signal is NOT readily available
– you can manually set the clock and calendar
(SEE MANUAL SETTING INSTRUCTIONS)
After the clock acquires the Atomic clock radio signal (this may take 24-48 hours)
the time, date and daylight saving time changes will update automatically, giving you
maintenance-free operation and perfect time precision.
BASIC SETUP
Time Zone will
default to PST
(Pacific Standard Time)
Signal Indicator
will be flashing
Room Temp indicator
will be flashing
PST
Pacific Standard
Time
MST
Mountain Standard
Time
CST
Central Standard
Time
EST
Eastern Standard
Time
HAST
Hawaii Aleutian
Standard Time
AKST
Alaska Standard
Time
AST
Atlantic Standard
Time
