Acura TL 2013, Руководство пользователя

Страница: 559 / 650

The headlights were properly aimed
when your vehicle was new. If you
regularly carry heavy items in the
trunk, readjustment may be
required. Adjustments should be
done by your dealer or another
qualified technician.
Your vehicle has halogen high beam
headlight bulbs which are also used
for the daytime running light.
Handle it by its base and protect the
glass from contact with your skin or
hard objects. If you touch the glass,
clean it with denatured alcohol and a
clean cloth.
Open the hood.
Remove all engine compartment
covers (see page
).
The low beam headlight bulbs are a
type of high voltage discharge tube.
High voltage can remain in the
circuit even with the light switch off
and the key removed (or the vehicle
is in VEHICLE OFF (LOCK) mode
on models with keyless access
system). Because of this,
you should not attempt to examine
or change a low beam headlight
bulb yourself. If a low beam
headlight bulb fails, take the vehicle
to your dealer to have it replaced.
If you are replacing the bulb on
the driver’s side, remove the
holding clips with a flat-tip
screwdriver. Then remove the
upper part of the air intake duct by
pulling it straight up.
1.
2.
542
CONTINUED
Headlight Aiming
Low Beam Headlight
Bulb Replacement
Replacing a High
Beam Headlight/Daytime
Running Light Bulb
Lights
Ma
int
e
na
nce
555
HOLDING CLIP
Halogen bulbs get very hot when lit. Oil,
perspiration, or a scratch on the glass
can cause the bulb to overheat and
shatter.
12/07/20 11:41:36 31TK4640_560
2013 TL