Page
16
of
22
23.
Check the Moonroof One-Touch Feature
Make sure the moonroof one-touch feature works right:
•
When you firmly pull the moonroof switch backward and release it, the moonroof should fully open.
•
When you firmly push the switch forward and release it, the moonroof should fully close.
•
When you push up on the switch and release it, the moonroof should tilt.
If the moonroof does not work right, do this procedure to calibrate it:
NOTE:
•
Calibration is not needed after disconnecting the battery.
•
Calibrate the moonroof one-touch feature after replacing any moonroof components or after installing the accessory
moonroof visor.
1. Close the driver’s door and leave it closed until the procedure is done.
2. Turn the ignition to OFF.
3. Press and hold the tilt switch and turn the ignition to ON
4. Release the tilt switch and turn the ignition to OFF.
5. Repeat steps 3 and 4 four more times.
6. Check if the auto open and auto close functions still work. If they do, the auto functions have not been cleared.
Go back to step 1. If the auto functions have been cleared, go to step 7.
7. Press and hold the moonroof open switch for at least 3 more seconds after the moonroof is fully open.
8. Press and hold the moonroof close switch for at least 3 more seconds after the moonroof is fully closed (tilted).
9. Make sure the moonroof control unit is reset by using the moonroof auto open and auto close function.
NEW MODEL SERVICE INFORMATION
1.
VIN Location
The VIN is beneath the front passenger’s floor mat under a cover in the floor panel.
