© 2012 American Honda Motor Co., Inc. - All Rights Reserved.
15
B127121H
Starting the Engine
10-minute mode
1.
Push and release the engine/command button on
the transmitter, then push in the lock/start button
within 2 seconds.
2.
The transmitter emits two rapid beeps and sends a
signal to start the engine.
3.
When receiving the answerback signal from the
vehicle, the transmitter emits two rapid beeps, and
the reception indicator is shown on the display.
4.
The checking indicator is blinking until the engine
start is confirmed.
5.
After starting the engine, the transmitter emits
another sound, and the each indicator is shown on
the display.
1
ENGINE/
COMMAND
BUTTON
LOCK/
START
BUTTON
ENGINE
RUNNING
INDICATOR
CHECKING
INDICATOR
(Blinking)
REMAINING
IDLING TIME
IN-CAR
TEMPERATURE
*
1
*
1 Only on vehicles equipped with the automatic climate control.
This indicator is displayed for some vehicles among them.
RECEPTION
INDICATOR
*
1
NOTE: If the engine does not start with the remote
starter transmitter, the transmitter will emit two short
beeps to indicate the signal has been sent. It will then
emit a long buzzer sound and the indicator is shown in
the display to indicate the engine start was not
successful. Refer to the section of trouble shooting for
further information
(page 34)
.