©
201
7
American Honda Motor Co., Inc. – All Rights Reserved.
BII06384-30 (1705)
7 of 8
23. Plug the vehicle connector into the cable reel.
24. Install the airbag on the new steering wheel.
•
Make sure that the harness does not get caught
between the steering wheel and the airbag.
•
Alternately tighten the right and left TORX bolts
so that the clearances between the steering
wheel and horn pad are equal on both sides.
Torque the TORX bolts to 10 N·m (7.2 lb·ft).
•
TORX bolts are coated with loctite, so they
cannot be reused. When installing the airbag,
use the TORX bolts included in this kit.
QA00414AB
NEW STEERING WHEEL
AIRBAG
2 NEW TORX BOLTS
Torque: 10 N
·
m
(7.2 lb
·
ft)
HORN PAD
Make sure the clearances
are equal on both sides.
25. Reconnect the horn connector and the airbag
connector. To reconnect the airbag connector, hold
the pawl-side connector, and push on the back of the
sleeve-side connector. Do not hold the sleeve, the
sleeve is pushed back by the pawl as the two airbag
connectors mate.
26. Secure the airbag connector and horn connector to
the cable guide.
27.
I
nstall the access panel.
28. Check that all wire harnesses are routed properly
and all connectors are plugged in.
873002AR
CABLE
GUIDE
ACCESS
PANEL
SPRING-LOADED
SLEEVE
4 RETAINING
TABS
AIRBAG
CONNECTOR
HORN
CONNECTOR
AIRBAG
