©
201
7
American Honda Motor Co., Inc. – All Rights Reserved.
BII06384-30 (1705)
1 of 8
08U97-TX4-2000-90
VERSION 1
Publications No.
Issue Date
INSTALLATION
INSTRUCTIONS
Accessory
Application
STEERING WHEEL
P/N 08U97-TX4-200
201
8
RDX
MAY
201
7
PARTS LIST
Steering wheel
2 TORX bolts
Steering wheel bolt
Information
TOOLS AND SUPPLIES REQUIRED
Phillips screwdriver
10 mm Open end wrench
10 mm Hex bit
Ratchet
T30 TORX bit
Torque wrench
Steering wheel puller
HDS
The following tool is available through the
Acura
Tool and
Equipment Program. On the iN, click on: Service >
Service Bay > Tool and Equipment Program, then enter
the number under “Search.” Or, call 888-424-6857.
Plastic Trim Tool (T/N SILTRIMTL10)
Illustration of the Steering Wheel in the Vehicle
INSTALLATION
NOTE:
• Observe all safety notes and precautions in the service
manual in addition to those in this installation
instruction.
• Be careful not to damage the vehicle.
• After installing the steering wheel, you must align the
steering wheel spoke angle to the straight ahead
position by adjusting the front toe.
1.
Turn the steering wheel so the front wheels are in the
straight-ahead position.
2.
Disconnect the negative cable from the battery, and
wait at least 3 minutes before you start to install the
steering wheel.
Client Information:
The information in this installation
instruction is intended for use only by skilled
technicians who have the proper tools, equipment, and
training to correctly and safely add equipment to your
vehicle. These procedures should not be attempted by
“do-it-yourselfers.”
QA00402AB
STEERING WHEEL
