173
uu
Operating the Switches Around the Steering Wheel
u
Auto High-Beam
Co
ntrols
■
To manually cancel the system temporarily
You can cancel the operation when you manually change the headlights to high
beams. Push the lever forward until you hear a click, or lightly pull the lever towards
you to flash high beams. The auto high-beam indicator goes off.
If you want the auto high-beam operation to resume at once, pull the lever towards
you.
Adjust the system when the vehicle is parked
with the power mode in ON and the light
switch is in the
AUTO
position.
To disable the system:
Pull the light switch
lever towards you and hold it for 40 seconds.
The auto high-beam indicator in the meter will
blink twice.
To enable the system:
Pull the light switch
lever towards you and hold it for 30 seconds.
The auto high-beam indicator in the meter will
blink once.
To set the high sensitivity:
Pull the light
switch lever towards you and hold it for 2
minutes.
The auto high-beam indicator in the meter will
blink three times. The setting is reset when the
power mode is set to VEHICLE OFF (LOCK).
■
To Adjust the System
1
To Adjust the System
The auto high-beam is in the previously selected
disabled or enabled setting each time you start the
engine.
AUTO
Position
17 ACURA MDX-31TZ56300.book 173 ページ 2016年10月25日 火曜日 午後2時27分
Содержание MDX2017
