Page
11
of
13
17.
Check Bluetooth
®
HandsFreeLink
®
(HFL)
To ensure HFL works and is ready to use, start the engine, then press and hold the Hang-up/Back button on the
steering wheel for
10 seconds
. You should hear “The TCU is OK.” If you do not hear this message, see the service
information for troubleshooting information.
18.
Check the Moonroof One-Touch Feature
Make sure the moonroof one-touch feature works properly:
•
When you firmly pull the moonroof switch backward and release it, the moonroof should fully open.
•
When you firmly push the switch forward and release it, the moonroof should fully close.
•
When you push up on the switch and release it, the moonroof should tilt.
If the moonroof does not work properly, do this procedure to reset the control unit:
NOTE: This procedure must be done after replacing any moonroof component or after installing the accessory
moonroof visor. It does not need to be done after disconnecting the battery.
1. Close the driver’s door and leave it closed until the procedure is finished.
3. Press the tilt switch to put the moonroof in the tilt position.
4. Turn the ignition to OFF.
5. While pressing and holding the tilt switch, turn the ignition to ON.
6. Release the tilt switch and turn the ignition to OFF.
7. Repeat steps 3 and 4 four more times.
8. Hold the moonroof switch in the Open position until the moonroof fully opens.
9. Hold the moonroof switch in the Closed position. The moonroof will close and then go to the tilt position. Keep
holding the moonroof switch until the moonroof is tilted fully open.
10. Release the moonroof switch.
11. Make sure the one-touch feature works in the Open, Close, and Tilt positions.
