Acura Embedded Systems RoughNeck-15, Руководство пользователя

Страница: 14 / 24

14
RoughNeck-15
AP15HBCD-XX
Installation Procedures
AP15HBCD is designed and pre-configured for easy setup and use. This section describes the installation
steps you should follow to get the system running as quickly as possible.
Connecting the Power Cord
1. Connect the DC Extension cable plug (4pin female) to the computer’s Power Supply Connector.
2. Connect the other DC Extension cable (4pin male) to the power adapter
3. Turn on the DC power supply
(1)
(2)
HAZARD OF ELECTRIC SHOCK, EXPLOSION OR ARC FLASH
•
Remove all power from the device prior to installing or removing any accessories, hardware,
or cables.
•
Always use a properly rated voltage sensing device to confirm power is off.
•
Unplug the power cable from both the Panel PC and the power supply.
•
Replace and secure all covers or elements of the system before applying power to the unit.
•
Use only the specified voltage when operating the Panel PC. The DC unit is designed to use
12V DC. Always check whether your device is AC or DC powered before applying power.
Failure to follow these instructions will result in death or serious injury.
Connect the equipment to a properly grounded safety extra low voltage (SELV) with Limited Power
Source (LPS). The power source is a secondary circuit that is designed so that normal and single fault
conditions do not cause the voltages to exceed the safe level.