The Remote Transmitters
3
Ignition key
The system is supplied with 2 transmitters, 1 flip fob and 1 lightweight
fob. The key blank for the flip fob is supplied by Acumen on receipt of
their copy of the certificate of installation.
When all three buttons are pressed at once and held
for 5 seconds
With ignition off
- Silent arm/disarm is toggled (14 flashes on/7 off)
With system armed or disarmed
- on/off
With ignition on, system disarmed
- Nudge sensor toggled on/off
(6 flashes on/3 off)
With ignition off, system in service mode
- Indicators on warning
function is toggled on/off (5 flashes on/10 off)
Standard Settings of the system
When the system arms, immobilisation and hot wire (ignition circuit
becomes live) functions only will be enabled.
The system will arm automatically 50 seconds after the ignition is
switched off. (This time cannot be altered)
You can manually arm the system by pressing the lock (key) button. (You
will get 2 beeps and 2 flashes of the indicators) (see section 6)
To disarm the system, press the lock (key) button. (You will get 1 beep
and 1 flash of the indicators) (see section 6)
The system will arm with an audible warning of arming.
P
P
This button will;
•
Deactivate/activate tilt
and vibration,
•
Select siren tone,
•
Select number of
digits in PIN
This button will;
•
Arm & disarm the system,
•
Allow you to enter Diagnostic
and Service Modes.
This button will;
•
Activate the torch
This button will;
•
Allow the ignition key
to swivel out
These screws (x2) at-
tach the ignition key
to the transmitter
Replacement battery type CR2016
Note: when the batteries are becoming
discharged, the alarm will give a low
battery warning of six rapid beeps
every time the key fob is used.
