Acuity Brands Aculux AX3 A WDTW, Инструкция по установке, Страница: 4 / 5

1300 S. Wolf Road • Des Plaines, IL 60018 • Phone 800-323-5068 • Visit us at www.acuitybrands.com/aculux
©2017 Acuity Brands Lighting, Inc. Rev 3/17 P6160
Product Services Phone (888) 387-2212
4 of 5
INSTALLATION INSTRUCTIONS
DMX Downlight Installation
1. DMX Cable needs to meet the ANSI/TIA/EIA-485 standard for DMX-512 and have nominal characteristic impedance of 120 Ohms.
2. Termination resistors are included with each luminaire and should remain installed in the last luminaire of each run to prevent erratic network behavior.
3. No more than 30 fixtures may be installed on a single run.
4. No more than 1000 ft. of wire may be installed on a single run.
5. No T-TAPS, STARS (except by a DMX/RDM splitter), splices, or Ys allowed.
6. All fixtures intended to be controlled as a zone should be given the same DMX start address. Fixtures default to a start address of 1.
7. The following RDM configuration devices are recommended for fixture addressing and configuration
a) Acuity Controls Fresco DXT-1M12-2M09-NE1L and Pathport Manager 5.3 software
b) Fresco FCS7TSNX
DMX Installation Guide
Commissioning with Remote Device Manage (RDM)
After the fixtures are properly wired together as a DMX network (also known as a DMX universe):
1. Use an RDM controller (such as Fresco) that is compliant with ANSI E1.20 - 2010 Entertainment Technology RDM
Remote Device Management Over DMX512 Networks requirements.
2. Set the address(s) for the fixture(s) (addresses are also known as slots).
3. Do not use other personalities before consulting with factory.
4. After commissioning, do not operate the system with RDM and DMX messages at the same time.
Supported RDM PIDs
DMX-RDM PIDs
Standard PID definition
Req Get Set Aculux
PID Implementation Aculux Tunable White/BBD
PID Implementation
Disc_Unique_Branch Yes Yes
Disc_Mute Yes Yes
Disc_Un_Mute Yes Yes
Supported_Parameters Yes Yes
Parameter_Description Yes Yes
Device_Info Yes Yes
Software_Version_Label Yes Yes
DMX_Start_Address Yes Yes Yes
Identify_Device Yes Yes Yes
Device_Model_Description Yes Aculux Aculux BBD and Tunable White
Manufacturer_Label Yes Acuity Brands Juno Lighting Group
Device_Label Yes Yes Settable Aculux IC/TC410T(SQ)
DMX_Personality Yes Yes N/A See Table of Personalities
DMX_Personality_Description Yes N/A See Table of Personalities
Curve Yes Yes Logarithmic and Linear,
Preset to Logarithmic N/A
Curve_Description Yes See note above N/A
For TW/BBD Aculux only:
Please use personality 2 for Black Body Dimming (BBD), also known as Warm Dimming, or personality 5
for Tunable White (CCT Tuning). Consult with factory before using other personalities.
DMX-RDM
Personalities
Item
Personality Slots Slot 1 Handle Slot 2 Handle Description
2 Warm Dimming
3000K SQ 1 Brightness n.a. BBD 1800-3000K,
square law response
5 Tunable White
4300K SQ 2 Brightness CCT CCT tuning 2000-4350K,
square law response
Table 1:
Table 2:
DISCONTINUED