DELIVERY: Upon receipt of fixture and accessories (packed separately), thoroughly
inspect for any freight damage. All damage should be reported to the delivery car-
rier. Compare the catalog description listed on the packing slip with the fixture label
on the inside of the housing to be sure you have received the correct merchandise.
This device complies with Part 15 of the FCC Rules. Operation is subject to the fol-
lowing two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Tools Required: 9/16" socket wrench. 1/4" socket wrench.
1)
To mount the fixture, open access door by loosening the captive screw
using 1/4" socket wrench. (See Figure 1).
Loosen the (2) hinge bracket screws and remove the access door.
2)
Place the flat bar stock with the 3 holes, two of which are threaded, inside
the pole, aligning with the drill pattern (shown on next page).
Place the cast aluminum block on the outside of the pole, with the word “Up”
towards the top of the pole and facing outward or away from the pole.
Thread the (2) 3/8" diameter hex head bolts through the block and pole into
the threaded bar stock.
(There is no gasket needed).
Check plumb and level of the block and secure bolts tightly with 9/16" wrench
or socket. (See Figure 2)
Figure 1
Installation Instructions
HLA LED
5 year limited warranty
Part Number: RJ521392 Rev A
Revision Date: 4/4/16
Lithonia Lighting Outdoor • One Lithonia Way • Conyers, Georgia 30012
Phone: 800-279-8041 • Fax: 770.918.1209 •
www.lithonia.com
© 2015 Acuity Brands Lighting, Inc. All rights reserved.
Figure 2
