Part Number: RJ521380 Rev B
Revision Date: 4-4-16
Installation Instructions
HLF LED
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Prior to Installation--Read carefully before installing ligh fixtures. If you do not understand these instructions, please contact your local
Lithonia Lighting distributor before installing.
DELIVERY: Upon receipt of fixture and accessories (packed separately), thoroughly inspect for any freight damage. All damage should be re-
ported to the delivery carrier. Compare the catalog description listed on the packing slip with the fixture label on the inside of the housing to
be sure you have received the correct merchandise.
5 year limited warranty
Lithonia Lighting Outdoor • One Lithonia Way • Conyers, Georgia 30012
Phone: 800-279-8041 • Fax: 770.918.1209 •
www.lithonia.com
© 2011 Acuity Brands Lighting, Inc. All rights reserved.
HLF YOKE
Yoke Mounting Plate Template Note: This drawing is NOT to scale and should be used for dimensional purpose only.
HLF1
HLF2
Tools Required: 9/16", 5/8", 3/4", and 1/4" wrench, regular screwdriver
Yoke Mount (YK)
:
Mount the yoke to the desired braketry by the center hole using a 3/4" bolt, lock washer, and nut (nut provided). 1/2" inch bolts can be used
in the two outer holes if needed. Tighten to 35-40 ft.-lbs. To adjust the tilt angle of the fixture, loosen the hex socket screw on each side of
the yoke. While holding weight of fixture, remove hexhead set screw, adjust as necessary and reinstall in appropriate matching hole. If a
non-standard angle is desired, adjust to angle and center punch inside yoke bracket and drill a .147in(#26) hole. Reinsert hexhead set screw.
Make the supply connections to the 16-3 cord supplied.
