Lithonia Downlighting
Part No.
CJ5201106
Rev. E
One Lithonia Way / Conyers, GA 30012
©20011 Acuity Brands Lighting, Inc., 12/11
800-315-4935 / www.lithonia.com
Page
2
of
5
INSTALLATION INSTRUCTIONS
6BPMW LED (6” Baffle LED Module); 5BPMW LED (5” Baffle LED Module)
4BPMW LED (4” Baffle LED Module)
Prior to installing the fixture, disconnect ALL power supplies to the unit. This module may be installed in TYPE IC or NON-IC
installations. For TYPE NON-IC INSTALLATION ONLY: No insulation may be placed over the top of or within 3” (76mm) of the
fixture.
INSTALLATION INSTRUCTIONS FOR 6BPMW LED AND 5BPMW LED
Step 1: 6BPMW LED - Determine Mounting Method
A. Housing with torsion brackets (see Figure 1); use torsion springs to
install LED module.
•
Go to Step 2 – Grounding Wire
B. Housing without torsion brackets; use retention clips to install LED
module.
1. Remove the springs (see Figure 2).
2. Select retention clip position (Figure 3).
•
Housing inside diameter 6.20” or less; use upper clip slots
(Figure 4). Insert clips at the upper three slots (Figure 6).
•
Housing inside diameter 6.20” or more; use lower clip slots
(Figure 5). Insert clips at the lower three slots (Figure 6).
3. Go to Step 2 – Grounding Wire
•
If the retention clips are in the bottom position (see Figure 4), make sure there are no obstructions that will interfere with the clips 1”
from the bottom of the recessed housing.
•
If the retention clips are in the top position (see Figure 5), make sure there are no obstructions that will interfere with the clips within 2-
1/4” from the bottom of the recessed housing
Step 1: 5BPMW LED - Determine Mounting Method
A. Housing with torsion brackets (see Figure 1); use torsion springs to install LED module.
•
Go to Step 2 – Grounding Wire
B. Housing without torsion brackets (see Figure 7); use retention
clips to install LED module.
1.
Remove top cap screws and discard the torsion spring
brackets.
2.
Insert three clips into upper slots.
3.
Go to Step 2 – Grounding Wire
Existing Housing
Figure 3
Figure 6
Figure 4
Figure 5
Figure 1
Torsion
brackets
Torsion springs
Figure 2
Top Cap Screws
Figure 7
Torsion
Bracket
