Troubleshooting:
Using the Reset button on the Indoor unit (receiver):
In some unusual occasions, the Indoor unit may be affected by electrical interference and respond
abnormally. In such conditions, press the RESET button on the Indoor Display unit to resume
normal operation. “RESETING” The Display unit should give you the indoor immediately and the
outdoor temperature within 1 minute.
Using the Reset button on the remote sensor (sender) In some unusual occasions, the remote sensor
may be affected by electrical interference and respond abnormally. In such conditions, press the
RESET button (located inside the battery compartment) on the remote sensor to resume normal
operation.
If you press the RESET button on the remote sensor, you MUST press the RESET button on the
Indoor Display unit (receiver) as well.
If or when the Indoor unit display “- - -“continuously in the outdoor window, it maybe that the
remote sensor is out of range or the batteries low. Please put the Remote sensor (sender) close to
the Indoor unit (receiver) or replace the fresh batteries.
Note:
If the Remote Sensor “RESET” button is pressed, or new batteries are installed in the Remote
Sensor, you MUST press the Reset button on the Indoor Display unit (receiver).
FCC Statement:
FCCID: RNE000782TXA1
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Caution: The user is cautioned that changes or modifications made to the equipment without the
approval of manufacturer could void the user’s authority to operate this equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
