http://www.advancedactuators.com
ReliTouch® User Manual
78
4) If fingerprint verification was successful, (two short beeps will be
heard,) the green LED will flash and the ReliTouch
®
RT-201 will
unlock (and remain unlocked for approximately four seconds).
If verification of the enrolled fingerprint was not successful on the
first attempt, the LED will flash red (no beeps). If this happens, re-
position the enrolled fingerprint on the sensor. The sensor will try
two more times to verify the enrolled fingerprint. If all three
attempts fail the LED will flash red three times and three short
beeps will be heard. Remove the enrolled fingerprint and start over
from the beginning of this section. Also, check to make sure that
the fingerprint being used has been enrolled.
If the LED flashes red three times, and three short beeps are heard,
after * or # button was pressed, this indicates that the matching
mode is set to 1:1.
If LED flashes red once, and one single beep is heard after a
successful verification, this indicates that User ID associated to the
enrolled fingerprint is either outside of their Timed Access settings,
OR their User ID is set to INVALID, OR the lock is set to
INVALID.
Illuminating the ReliTouch
®
RT-201 Exterior Unit Keypad
Press and Hold
any of the numbers on the keypad (0 thru 9)
for
two to three seconds
on the exterior unit.
Keypad will illuminate.
www.BuilderDepot.com
