8
The remote is synced with your BLINK S!
8
Step 1 :
Turn on the board
Step 2 :
Switch o your remote
Step 3 :
Put the remote into the (R) reverse
position. Open the battery case of the remote and
slide the button above the battery to the left
position.
Step 4 :
Turn on your phone’s bluetooth
Step 5 :
Open the ACTON App to your phone
(make sure you have the latest update)
Step 6 :
Once your board is connected to the App,
click your device name (board’s serial number),
then you’ll see there’s a remote icon on the upper
left corner. Click the remote icon and select OK.
Step 7 :
Your phone should show ready to re-sync
Step 8 :
While pulling the joystick back (brake
position), switch on the remote and continue
holding the brake
Step 9 :
The blue LED on the remote will begin
blinking at a higher frequency than normal show-
ing the remote is paired
Step 10 :
Put the remote back to (F) forward
position. Slide the button above the battery to the
right position
Step 11 :
Check to see if the remote is paired by
pushing the throttle forward. The wheel should
speed up and the board is ready to ride!
The remote is synced with your BLINK S!
8
Step 1 :
Turn on the board
Step 2 :
Switch o your remote
Step 3 :
Put the remote into the (R) reverse
position. Open the battery case of the remote and
slide the button above the battery to the left
position.
Step 4 :
Turn on your phone’s bluetooth
Step 5 :
Open the ACTON App to your phone
(make sure you have the latest update)
Step 6 :
Once your board is connected to the App,
click your device name (board’s serial number),
then you’ll see there’s a remote icon on the upper
left corner. Click the remote icon and select OK.
Step 7 :
Your phone should show ready to re-sync
Step 8 :
While pulling the joystick back (brake
position), switch on the remote and continue
holding the brake
Step 9 :
The blue LED on the remote will begin
blinking at a higher frequency than normal show-
ing the remote is paired
Step 10 :
Put the remote back to (F) forward
position. Slide the button above the battery to the
right position
Step 11 :
Check to see if the remote is paired by
pushing the throttle forward. The wheel should
speed up and the board is ready to ride!
The remote is synced with your BLINK S!
Step 1:
Switch o your remote
Step 2:
Put the remote into the (R)
reverse position. Open the battery case
of the remote and slide the button above
the battery to the left position.
Step 3:
Turn on your board
Step 4:
Use the clip to push the resync
button. The blinking light should be o
Step 5:
While pulling the joystick back
(brake position), switch on the remote
and continue holding the brake
Step 6:
The remote should be paired
with the board once the remote light is
flashing blue and the board light is
flashing green
The remote is synced with your BLINK
Lite V2
!
