6
CAUTION
WARNING
The following instructions will permit the unit's ActivePure
®
Cell to be safely replaced without creating safety concerns in your
professional environment.
Step 1:
Always disconnect (unplug) device from electrical power source before replacing the ActivePure
®
Cell
Step 2:
If necessary, relocate the device to an appropriate area to perform cell replacement. Do not replace
cell in areas where exposure may occur.
Step 3:
Remove the 4 screws securing the old cell mounting plate on the device.
Step 4:
Slide the old cell out of the device and disconnect the bulb socket.
Step 5:
Open the replacement cell carton and remove the new cell.
Step 6:
Place old cell inside the empty new cell carton and dispose of properly.
NOTE:
No special handling for contaminants is necessary as the cell is on the exhaust side of the device and
does not trap or contain contaminants.
Step 7:
Reattach the bulb connection to the new cell.
Step 8:
Slide the new cell back inside the device and secure with the 4 screws removed in Step 3.
Step 9:
Plug device in and reset the ActivePure
®
Cell Change Light by pressing and holding the power
button for 4 ~ 5 seconds until it goes out.
Step 10:
The device is now ready to be returned to its location.
STEP 1:
Open the front door from
the right hand side.
STEP 2:
Remove old filter.
STEP 4:
Replace with new ActivePure
®
HEPA particle filter.
STEP 3:
Clean ion chamber.
STEP 5:
Close front door.
Disconnect power before changing filter.
Use only replacement part recommended by the manufacturer.
REPLACEMENT PARTS (QTY)
Part Number
ActivePure
®
HEPA Filter (1)
49949
ActivePure
®
Cell/Bulb (1)
50086
To order replacement parts, contact your sales representative or ActivePure
®
Customer Service
for further assistance at 800.572.1446 or email [email protected].
CHANGING THE FILTERS
ACTIVEPURE
®
CELL REPLACEMENT INSTRUCTIONS
REPLACEMENT PARTS & SERVICE