again, the machine will stop completely and all the data will reset. But in this PAUSE state, if you press
START button, the treadmill will go on from the data of PAUSE state
“SPEED+/-”:
Adjust the speed. Press the button to adjust the speed when running, or adjust the data
when stop.
“SPEED
(
3,6,9,12
)
”
:
Adjust the speed quickly.
“/-”:
Adjust the incline. Press the button to adjust the incline when running, or adjust the
data when stop.
“INCLINE
(
3,6,9,12
)
”
:
Adjust the incline quickly.
Notice: When any button is pressed, it will be accompanied by a prompt tone. When the
button is adjusted for parameter overrun, it will be accompanied by a long tone prompt.
There is no beep when the button is pressed Invalid.
4. MAIN FUNCTION
Open the power switch, the screen window will light up, the machine will enter into standby state.
4.1. START-UP QUICKLY (MANUAL):
Put safety key, press ‘ START’ button, the treadmill will run at the lowest speed in 3 seconds, press
SPEED+/-
to adjust the speed. Press
/-
to adjust the incline. Press the ‘ STOP’ button or take
out the safety key directly to stop the treadmill.
4.2. COUNT DOWN MODE:
Press the ‘ MODE’ button, you can choose time countdown mode, distance count down mode, calories
countdown mode, and the screen window will show the default data and glitter. At the same time, press
SPEED+/-
and
/-
to set the data. Press ‘ START ’ button, the machine will run at the lowest
speed, you can press
SPEED+/-
to change the speed, press
/-
to change the incline. When it
counts down to 0, the machine will stop smoothly. Certainly, you can press ‘ STOP’ button or take out the
safety key from the computer to stop the machine.
4.3. INNER INSTALL PROGRAM:
Press ‘PROG’ button to choose the inner install program from P1----P15. When set the program, the time
window will show default data and glitter, press
SPEED+/- or /-
button to set the running time.
Each program has been divided into 16 section, Each exercise time=the setting time/16. Press ‘START’,
the machine will run at the first section speed and incline date. When the section is over, it will enter into
next section automatically, the speed and incline will change as next section data. When finish one
program, the machine will stop smoothly. During the running, you can change the speed and incline by
the
SPEED+/-
and
/- or Left/right Handrail Button
. When the program enter next section will
come back to the default date. And you can press ‘STOP’ or take out the safety key to stop the machine
whenever.
Содержание GB-K6480
Страница 4: ...Exploded Parts Diagram ...