4
TROUBLESHOOTING:
Watch is running one step every 2 seconds -
When battery level is low the watch runs one step every 2 seconds. Battery should be replaced.
Time announcement is different from the analog time of the watch -
You need to synchronize the hands to match the time announcement. Go to
Synchronize Hands to match Time Announcement
(below)
for details.
Synchronize Hands to match Time Announcement
1.
Pull out the crown of the watch when the Second Hand runs to 12:00:00 o’clock so that
the second hand stops at 12 o’clock. If you miss the 12 o’clock moment, wait for the
next chance.
2.
Turn the crown of the watch to set Hour and Minute hands pointing at 12 o’clock
3.
Now Hour, Minute and Second hands are all pointing at 12 o’clock with the Crown
pulled out
4.
Holding S1 (2 o’clock button) for more than 5 seconds with the Crown in this out
position
5.
Now push in the Crown
6.
Notice that the watch hands will begin to spin to match the time announcement
7.
Please wait until the watch resumes normal function
8.
Once movement has stopped, check to see if the time announcement and watch hands
are synchronized by pressing S1 (2 o’clock button) once. If they are synchronized, you
have successfully set the watch. If not, repeat Step 1 to 8.
Changing the Battery
There is only one CR2025 type battery inside the watch. This battery is used to drive both
the voice announcement as well as the gearbox.
When you need to change the battery it is better to go to a trained jeweller or watch
specialist to fit the new battery to avoid any damage to the watch.
ELSE-
Open the watch at the back. Carefully remove the back case, make sure you are not losing
the waterproof seal.
Pick up the battery spring on the right.
Take out the battery and insert a new one (watch the polarity – ‘+’ end up).
Now push the battery spring down.
Before you put the case back on again, make sure the waterproof seal is correctly in place.
After battery is replaced, you will need to reset your watch as follows:
1.
Set Time and Calendar according to “Setting the Time” and “Setting the
Calendar” as mentioned in these instructions.
2.
Then you need to synchronize the hands to match the speaking feature by
referring to “Synchronize Hands to match Time Announcement” in these
instructions.
